While I am waiting for some small things for engine work I have made a major decision. I have not found a floor rail kit or parts that i like so far and none that fit the outer curve in the floor board, so I am going to make my own. Here are the wax originals I am made in the garage. I used a piece of angle iron as a base then bent them to fit the body.
I will then transport the wax pieces to the shop and proceed to cast them out of aluminum to make my own rails. If this doesnt work out I can always melt the aluminum back down and use it for something else. And if I find something better along the way or afterwards then no real loss minus time.
No comments:
Post a Comment